Connector and pin faults.
The connector is the most frequently plugged connection in the whole system. Pins bend, contact surfaces oxidise, the locking pin wears out. The result ranges from sporadic dropouts to a probe the device no longer recognises at all.
How to spot it
This is the fault you can narrow down fastest in-house: plug the probe into a different port. If it shows the same image there, it is not the connector. If the fault disappears, the port or the plug is the suspect. Visual inspection of the pins under magnification belongs to it.
What we do
We clean and work on the contact surfaces, straighten or replace pins and renew the locking pin. As a rule that is a repair in the lower level range — and therefore the cheapest way to get an apparently defective probe back.
Usual repair level
Every repair is individual and quoted on request — depending on the probe model and its condition. After the analysis you receive a transparent quotation. Additional services: disinfection to ISO standards, collection across Europe, 24h express service.
Probe types affected
- Standard & matrix probes
- 3D/4D & matrix 3D/4D
- TEE & matrix TEE probes
- Flexible endoscopes
- Ultrasound endoscopes
Send in a probe with this fault
Five questions in the repair advisor, and at the end you get a completed enquiry form with an initial assessment.
Request a repairWhich manufacturers
This fault pattern occurs across all manufacturers. To the probes of yours: